Intel CPU overclocking

CPU overclock What is it?
Specified in the vendor's existing CPU clock than to be forced to operate at a higher clock speed.
Actually overclocked Intel or AMD officially recommended not.
The speed of the CPU FSB x drainage means the clock, the clock speed of operation.
Rise of higher CPU clock speed. Overclock to increase the clock by modifying the FSB and drainage portion of the overall purpose. In contrast, the under-clock.

Exists in parts of RAM, graphics card, etc. In addition to CPU overclocking.

Overclock caveat?
First overclocking shorten the life of the parts that should be very careful.
Never at any time is not a safe way to overclock manggajyeodo responsibility to him is that.
Of compatibility with each parts are also important. Attention, especially the first time that the overclockers hope.

Good for CPU overclocking the CPU?
Of models such as the CPU time of shipment remains with the same clock, such as Cache actually completely the same, and can not be used to actually Production Year, year of production shares (WeeK), and the yield of the code, depending on the degree of well-overs CPU varies greatly.
Code written yireongeot parking code.
A Q828A ... 28 weeks if the product code. Such as parking, such as yield, there is no guarantee.

Way of overclocking Intel CPU
Learn basic words ..
The clock FSB = front side bus.
MultiPlier = drainage
CPU Voltage = coulometry requires a little more CPU when overclocked. This section would require modifications.

Motherboard manufacturer for each different menu.
Sense seeking the care of a menu that allows you to overclock CPU is required.
Sometimes overclocking menu if you do not have to be careful because there is no will.

One of Intel's low-power system, C1E, EIST disable the function is needed.
Let's find out this release from the motherboard's CPU Configuration. If there is an entry labeled C1E, EIST named
Disable should try to

Touching the CPU portion of it finds then goes to the menu.
Will be part of the first ten thousand jindamyeon not touch lock in Take care of this part of the runners loose.
CPU Frequency, Multiplier, CPU Voltage will be
Of course, this name may differ from the main board.

When you apply the basic principles, simplifying the overclocking.
Multiples of the maximum number of the CPU, basically draining limit manually entered (not necessarily).
Q9550 drainage limit the maximum is 8.5, for example, you put a 8.5 in the drain part.

Suitable place to give the FSB to go then CPU frequency stabilized by the stabilization program. Now doegetda FSB parts do not raise too much at once.

FSB part number of the CPU more voltage rises need to be.
Carefully CPU Voltage portion is gradually promoted.
Sosut part and gradually give up the FSB is the same.

RAM (Random Access Memory) Clock and CPU FSB 1:1 synchronization
The speed of the FSB increases the speed of the RAM should give
This is basic. Typically DDR2 would have been commercially available.
Let's say you write PC-6400. PC-6400's clock is 800Mhz. PC-6400 silkeulreok
400MHZ of 6400/8/2 will work. Silkeulreok At this time, the maximum of the value of the FSB is the same. Ram silkeulreok and At this time, the state portion of RAM and CPU clock is 1:1.

FSB require a higher number if the action a little higher, Ram haejwoyaman.
Case RAM clocks if you are using the over-the

If you want to modify the timing of the ram, usually typically the case of DDR2 5-5-5-15 writes.
If this number is smaller than their RAM (screwed in) there is no need to touch.
4 or more constriction is much recommended because it affects memory yield and do not want.